Show Ip Mroute - Dell Z9500 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.1
E-Series legacy
command
Usage
After you enable multicast, you can enable IGMP and PIM on an interface. In
Information
INTERFACE mode, enter the ip pim sparse-mode command to enable IGMP
and PIM on the interface.
Related ip pim sparse-mode
Commands

show ip mroute

View the multicast routing table.
Z9500
Syntax
show ip mroute [vrf vrf-name] [static | group-address [source-
address] | count | snooping [vlan vlan-idIntroduced on the
S6000-ON.] [group-address [source-address]] | summary | vlt
[group-address [source-address] | count]
Parameters
vrf vrf-name
static
group-address
[source-
address]
count
1174
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— enables IGMP and PIM on an interface.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
(OPTIONAL) Enter the keyword static to view static
multicast routes.
(OPTIONAL) Enter the multicast group-address to view only
routes associated with that group. Enter the source-address
to view routes with that group-address and source-address.
(OPTIONAL) Enter the keyword count to view the number of
multicast routes and packets.
Multicast