Dell Z9500 Reference Manual page 1497

Hide thumbs Also See for Z9500:

Table of Contents

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

pre- 6.2.1.1

ip prefix-list

Routing Information Protocol (RIP)

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

(OPTIONAL) Enter the keyword connected to filter only

directly connected routes.

(OPTIONAL) Enter the keyword isis to filter only IS-IS

(OPTIONAL) Enter the keyword ospf to filter all OSPF routes.

(OPTIONAL) Enter the keyword static to filter manually

configured routes.

Introduced on the S6000-ON.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— enters PREFIX-LIST mode and configures a prefix list.