Storing And Selecting Cutter Pen Condition Setting Areas; Setting Tool (Cutter Blade Or Pen) - GRAPHTEC CE-3000-120 AP User Manual

Storing and Selecting Cutter Pen Condition Setting Areas

Eight different sets of user-defined cutting conditions can be registered in the plotter's memory as
COND Nos. 1 through 8. To specify a set of cutting conditions, you must first select the destination
COND. No. By selecting a different COND No., you can easily switch between pre-defined cutting
conditions for eight sets of media.
CHECKPOINT
The pen number settings for the CE3000-120AP are as follows:
Command-specified
pen number
Storage method
Press the
2 0 9 U + 1 2 3 3 0 2
The current settings are displayed (from the left): condition number, PEN TYPE (cutter blade),
CUTTER OFFSET, FORCE, SPEED, and QUALITY.
The item to be changed is indicated by the t symbol. Press the
s, and press again to move it to the right. Press the
key to select the parameter to be changed, and use the
details. Press the
(PREV.), or
Selection method
To select condition settings that have previously been stored, use the
desired condition number stored on the cutter-pen-condition settings display (the number at the left
of the display), and then press the
(PREV.), or

Setting TOOL (cutter blade or pen)

Set the type of pen (cutter blade) to be used.
(1) Press the
(2) Select the setting area (condition number) to be set, and then press the
the s symbol to the position shown below.
2 0 9 U + 1 2 3 3 0 2
(3) Press the
to confirm the selection. If other conditions are to be set, press the
s symbol to the parameter to be set.
COND. No.
1 1
2 2
3 3
4 4
8 8
(COND.) key in READY mode to display the cutter-pen conditions.
(ENTER) key to confirm. To cancel the selection, press the
(COND.) key.
(COND.) key.
(COND.) key in READY mode to display the cutter-pen conditions.
or key to select "09U," "15U," "15B," or "PEN." Press the
Physical
pen number
1
(Pen holder)
2
(Cutter pen holder)
key to move it to the left. Use the
(ENTER) key. To cancel the selection, press the
Basic Settings and Operations
key to change the symbol to
or key to select the setting
(NEXT),
or key to select the
or key to move
(ENTER) key
or key to move the
or
(NEXT),
3-3