Selecting Tool Condition; Setting The Tool Condition - GRAPHTEC FC8000 Series User Manual

2 -
9

Selecting Tool Condition

Tool conditions can be set in 8 settings from 1 to 8. Then, you can switch between 8 predefined different
setting for different media by switching the settings.
Operation
Press the [CONDITION] key in the default screen.
1
CONDITION setting screen (1/3) is displayed.
Press the [1] key.
2
CONDITION No. selection screen is displayed.
Press the POSITION (¡ã¡å ) key and select the setting
3
(CONDITION No.).
Confrm the setting and press the [ENTER] key (SET).
4
Setting will be set, and it will return to CONDITION screen (1/3).
Press the [CONDITION] key.
5
It will return to the default screen.

Setting the Tool Condition

This section describes how to make the tool, speed, force,
acceleration, and tool number settings.
Before cutting media, the following five cutter-pen conditions must
be specified.
(1) Cutter-blade length .............Adjust the blade length by referring
(2) FORCE................................Set the FORCE by referring to the
(3) SPEED: . ...............................Set the SPEEDby referring to the
(4) QUALITY.............................Set the QUALITY by referring to the
(5) OFFSET...............................Set to suit the cutter blade being
to the media thickness table below.
table below.
table below.
table below.
used.
2-24
Supplement
Name of the media assigned in "Cutting Plotter
l
controller" is displayed as the CONDITION No.
name.
CONDITION No. can also be changed from
l
READY status. See "Changing CONDITION
No." P .3-6 .
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION (? ) key (CANCEL).
POSITION
Supplement
l See the appropriate references for details about
the "Setting Cut Line Pattern"
"Setting the T angential Emulation"
"Setting Length of the Overcut"
"Setting the Distance Adjust"
"Setting of the Initial Down Force"
l See "Adjust the Blade Length Manually"
P .2-31 and "Adjust the Blade Length
(Automatic Height Adjust)"
length adjustment methods.
P .7-15 ,
P .7-3 ,
P .7-4 ,
P .7-13 , and
P .7-6 .
P .2-36 for blade