Selecting Cutter-Pen-Condition Setting Areas; Storing Cutter-Pen-Condition Setting Areas; Setting Tool (Cutter Blade Or Pen) - GRAPHTEC CE3000-40 User Manual

To preserve the pen life, set the FORCE to the lowest setting, and set the SPEED after checking to confirm
that there are no faint lines or other problems during plotting.
CHECKPOINT
• If the SPEED and QUALITY settings are set to high values, the cut/plotted
• If the SPEED and QUALITY settings are set to low values, the cut/plotted results
I Selecting Cutter-Pen-Condition Setting Areas
To set the cutter-pen conditions, first select the setting area (condition number). Switching between these
setting areas enables any of up to eight predefined media types to be selected easily.
Selection method
Press the (COND.) key in READY mode to display the cutter-pen conditions.
2 0 9 U + 1 2 3 3 0 2
To select condition settings that have previously been stored, select the condition number stored on the
cutter-pen-condition settings display (the number at the left of the display), using the
press the (ENTER) key. To cancel the selection, press the
key.
I Storing Cutter-Pen-Condition Setting Areas
The cutter-pen conditions can be stored in eight setting areas numbered "1" to "8."
Storage method
Press the (COND.) key in READY mode to display the cutter-pen conditions.
2 0 9 U + 1 2 3 3 0 2
The current settings are displayed (from the left): condition number, PEN TYPE (cutter blade), CUTTER
OFFSET, FORCE, SPEED, and QUALITY.
The item to be changed is indicated by the
press again to move it to the right. Press the
the parameter to be changed, and use the
(ENTER) key to confirm. To cancel the selection, press the
CHECKPOINT When using the optional registration mark scanner, condition settings 1 and 2 are
used for the pen settings when performing "Adjusting the Registration-mark Read-
ing Sensor (2)" (refer to page 4-17). It is therefore more convenient if the cutter pen
settings are assigned to 3 to 8 first.
I Setting TOOL (cutter blade or pen)
Set the type of pen (cutter blade) to be used.
1
Step
Press the (COND.) key in READY mode to display the cutter-pen conditions.
results will have a coarser finish, but the overall cutting/plotting time will be
reduced.
will have a finer finish, but the overall cutting/plotting time will be longer.
(NEXT),
symbol. Press the
key to move it to the left. Use the
or key to select the setting details. Press the
(NEXT),
3 – 6
and
(PREV.), or
key to change the symbol to
or
(PREV.), or (COND.) key.
keys, and
(COND.)
, and
key to select