Setting Initial Blade Direction
The direction of blade is adjusted by making the blade touch the media right after the power is turned on,
or after the pen condition is set. This is called the initial blade direction adjust. Since this action makes the
blade touch the media, the position to perform the initial blade direction adjust is set to where it does not
affect the actual cuttings.
Initial blade direction adjust is performed 2 mm below (2 mm toward the feed direction) of the start of the
cut when "2mm BELOW" is selected.
Initial blade direction adjust is performed outside the cutting area when "OUTSIDE" is selected.
Press the [MENU] key.
MENU screen is displayed.
Press the  key (TOOL).
TOOLSSETTING screen (1/3) is displayed.
Press the POSITION (¡ã ) key.
TOOLSSETTING screen (3/3) is displayed.
Cutting Origin Point
of initial blade
(Set as"2mm BELOW")