Setting Initial Blade Direction Adjust - GRAPHTEC FC8000 SERIES User Manual

7 -
Setting Initial Blade Direction
6
Adjust
The direction of blade is adjusted by making the blade touch the media right after the power is turned on,
or after the pen condition is set. This is called the initial blade direction adjust. Since this action makes the
blade touch the media, the position to perform the initial blade direction adjust is set to where it does not
affect the actual cuttings.
Initial blade direction adjust is performed 2 mm below (2 mm toward the feed direction) of the start of the
cut when "2mm BELOW" is selected.
Initial blade direction adjust is performed outside the cutting area when "OUTSIDE" is selected.
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3
Press the POSITION (▲) key.
TOOLS SETTING screen (3/3) is displayed.
Next page
Cutting Origin Point
Position of initial blade
direction adjust
X
(Set as"2mm BELOW")
Y
7-18
2mm 2mm BELOW
POSITION
Push roller
OUTSIDE