Table of Contents
Advertisement
3 -
5
Stop Cutting
It will stop cutting when the [STOP] key is pressed while cutting. Operation selection menu is displayed on
the screen of the control panel while it is stopped. It is possible to choose either to continue or stop the
operation.
It is also possible to exchange or reset the media while it is stopped.
Pause and Resume Cutting
Operation
1
Press the [STOP] key.
Cutting will stop and following screen is displayed.
2
Perform necessary operation, such as exchanging the media.
3
Press the [1] key (CONTINUE JOB).
Cutting will start and the screen will resume to operation.
Supplement
There is no effect on the selection of media type
when the media set lever is moved up and down
while pausing the cutting. It is also possible to
exchange or reset the media.
Supplement
It will stop cutting by pressing [2] key (QUIT JOB).
See "Stop Cutting"
3-12
P.3-13
.
Advertisement
Table of Contents
Troubleshooting
