Pppoa Set Transport Port - Ericsson HM4x0 Reference Manual

PPPoA CLI Commands
16.32

pppoa set transport port

16.32.1 Syntax
pppoa set transport {<name>|<number>} port <port>
16.32.2 Description
This command applies to existing PVC transports – it does not apply to SVC
transports. This command sets the port that an existing transport uses to
transport PPPoA data.
The port/VPI/VCI combination must be unique for each transport.
16.32.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
port
16.32.4 Example
--> pppoa set transport pppoa4 port a1
420
Description
A name that identifies an existing
PPPoA transport. To display transport
names, use the pppoa list
transports command.
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the pppoa list
transports command.
The system port that is used to
transport ATM data.
Default value
N/A
N/A
N/A
2/1553-ZAT 759 94 Uen B – December 2005