Pppoa Set Transport Lcpmaxfail - Ericsson HM4x0 Reference Manual

PPPoA CLI Commands
16.25

pppoa set transport lcpmaxfail

16.25.1 Syntax
pppoa set transport {<name>|<number>} lcpmaxfail <lcp max
fail>
16.25.2 Description
This command sets the Link Control Protocol (LCP) maximum fail number for
an existing PPPoA transport.
16.25.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
lcp max fail
16.25.4 Example
--> pppoa set transport pppoa1 lcpmaxfail 20
412
Description
A name that identifies an existing
PPPoA transport. To display transport
names, use the pppoa list
transports command.
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the pppoa list
transports command.
Link Control Protocol; the maximum
number of consecutive negative
acknowledgements (indicating that the
information received contains errors)
that can be transmitted before
assuming that parameter negotiation
is not converging. The LCPmaxfail can
be any positive value.
Default value
N/A
N/A
5
2/1553-ZAT 759 94 Uen B – December 2005