Nat Show Globalpool - Ericsson HM4x0 Reference Manual

14.9

nat show globalpool

14.9.1 Syntax
nat show globalpool <name> <interfacename>
14.9.2 Description
This command displays information about a single network address pool that
has been added to an outside interface:
•
•
•
•
14.9.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
interfacename
14.9.4 Example
--> nat show globalpool gp1 extinterface
2/1553-ZAT 759 94 Uen B – December 2005
Type of inside interface (internal or DMZ).
Subnet configuration status (true if the network pool was set using a
subnet mask, false if it was set using a range of IP addresses).
IP address - the outside network IP address or the first address in the
range of addresses.
Subnet Mask or End Address - the subnet mask of the outside network IP
address or the last address in the range of addresses.
Description
A name that identifies an existing
global IP address. To display global
IP addresses, use the nat list
globalpools command.
The name of an existing security
interface (external or DMZ) created
and connected to an inside interface
(DMZ or internal) using the nat
enable command. To display
security interfaces, use the
security list interfaces
command.
NAT CLI Commands
Default value
N/A
N/A
349