Pppoe Set Transport Enabled|Disabled - Ericsson HM4x0 Reference Manual

PPPoE CLI Commands
17.16

pppoe set transport enabled|disabled

17.16.1 Syntax
pppoe set transport {<name>|<number>} {enabled|disabled}
17.16.2 Description
This command explicitly enables/disables a PPPoE transport. Attaching a
transport to an interface implicitly enables it, but for cases where no attach is
performed (for example, multiple channels on an interface, a PPP session that
is not attached but needed for testing purposes) the transport must be enabled
explicitly.
17.16.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
enabled
disabled
17.16.4 Example
--> pppoe set transport pppoe1 enabled
468
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the pppoe list
transports command.
Enables a PPPoE transport.
Disables a PPPoE transport.
Default value
N/A
N/A
disabled
2/1553-ZAT 759 94 Uen B – December 2005