Table of Contents
Advertisement
PPPoE CLI Commands
17.10
pppoe set transport bt
17.10.1
Syntax
pppoe set transport {<name>|<number>} bt <burst
tolerance>
17.10.2
Description
This command sets the burst tolerance (bt) for an existing PPPoE transport.
This command is only valid if you set VBR or VBR RT as the QoS Class using
the pppoe set transport qosclass command.
17.10.3
Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
burst
tolerance
17.10.4
Example
--> pppoe set transport pppoe1 bt 5
462
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the pppoe list
transports command.
Controls the duration of traffic bursts
on VBR (Variable Bit Rate) and VBR
RT (VBR Real Time) channels. This
value overrides an existing MBS value
(if set). The BT can be any value
between 0 and 100.
Default value
N/A
N/A
0
2/1553-ZAT 759 94 Uen B – December 2005
Advertisement
Table of Contents
