Ip Set Interface Rip Accept - Ericsson HM4x0 Reference Manual

IP CLI Commands
12.26

ip set interface rip accept

12.26.1 Syntax
ip set interface {<name>|<number>}
{none|v1|v2|all}
12.26.2 Description
This command specifies whether or not an existing interface accepts RIP
messages. You can specify what version of RIP messages are accepted by
the interface.
When receiving RIP v1 messages, the IP stack tries to use the information it
has available to determine the appropriate subnet mask for the addresses
received.
12.26.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
none
v1
v2
280
Description
A name that identifies an existing IP
interface. To display interface names,
use the ip list interfaces
command.
A number that identifies an existing IP
interface. To display interface
numbers, use the ip list
interfaces command. The number
appears in the first column under the
heading ID.
The interface does not accept RIP
messages.
The interface only accepts RIP version
1 messages (RFC 1058).
The interface only accepts RIP version
2 messages (RFC 1723).
rip accept
Default value
N/A
N/A
none
2/1553-ZAT 759 94 Uen B – December 2005