Pppoe Add Transport Dialout Eth - Ericsson HM4x0 Reference Manual

PPPoE CLI Commands
17.3

pppoe add transport dialout eth

17.3.1 Syntax
pppoe add transport <name> dialout eth <interface> <port>
[accessconcentrator <concentrator>] [servicename
<servicename>]
17.3.2 Description
This command creates a PPPoE transport that performs dialout over Ethernet.
It allows you to specify the following information:
•
•
•
•
17.3.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
interface
port
452
The PPP interface to the channel that Ethernet will use.
The Ethernet port that will transport data.
Access concentrator (optional).
Service name (optional)
Description
An arbitrary name that identifies the
transport. It can be made up of one or
more letters or a combination of letters
and digits, but it cannot start with a
digit.
The PPP interface to a channel that
transports PPPoE data. A single
interface can be used by multiple
channels. The interface value can be
any positive integer.
The system port that is used to
transport Ethernet data. To display
Ethernet ports, use the ethernet
list ports command.
Default value
N/A
N/A
N/A
2/1553-ZAT 759 94 Uen B – December 2005