Table of Contents
Advertisement
Firewall CLI Commands
10.11
firewall show portfilter
10.11.1
Syntax
firewall show portfilter <name> <policyname>
10.11.2
Description
This command displays information about a single portfilter that was added to
a firewall policy using the firewall policy add portfilter command. The following
portfilter information is displayed:
•
•
•
•
•
•
•
•
•
10.11.3
Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
policyname
236
Portfilter name.
Transport type used by the protocol (e.g. 6 for SMTP).
Start of the port range.
End of the port range.
Inbound permission (true or false).
Outbound permission (true or false).
Raw IP – whether the portfilter uses a non-TCP/UDP protocol (true or
false).
TCP permission – whether the portfilter uses a TCP protocol (true or
false).
UDP permission – whether the portfilter uses a UDP protocol (true or
false).
Description
A name that identifies an existing
portfilter. To display portfilter names,
use the firewall list
portfilters command.
A name that identifies a firewall policy.
To display policy names, use the
firewall list policies
command.
Default value
N/A
N/A
2/1553-ZAT 759 94 Uen B – December 2005
Advertisement
Table of Contents
