Bridge Set Interface Acceptframetype - Ericsson HM4x0 Reference Manual

4.41

bridge set interface acceptframetype

4.41.1 Syntax
bridge set interface {<name>|<number>} acceptframetype
{acceptall|accepttaggedonly}
4.41.2 Description
This command specifies whether the bridge interface accepts only VLAN
tagged frames or it accepts all the incoming frames. If the interface accepts all
incoming frames, it assigns its PVID to the untagged or priority tagged frames.
See the bridge set interface pvid command to set the PVID for an
interface.
4.41.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
acceptall
accepttagged
only
4.41.4 Example
--> bridge set interface bridge1 acceptframetype
acceptall
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
bridge interface. To display interface
names, use the bridge list
interfaces command.
A number that identifies an existing
bridge interface. To display interface
numbers, use the bridge list
interfaces command. The
number appears in the first column
under the heading ID.
Accepts all the incoming frames.
Accepts only VLAN tagged frames.
See the bridge show
interfacestats command to
know the incoming frames discarded
due to acceptable frame type
filtering.
Bridge CLI Commands
Default value
N/A
N/A
acceptall
83