Pppoe Set Transport Lcpechoevery - Ericsson HM4x0 Reference Manual

PPPoE CLI Commands
17.25

pppoe set transport lcpechoevery

17.25.1 Syntax
pppoe set transport {<name>|<number>} lcpechoevery
<interval>
17.25.2 Description
This command tells a specified PPP transport to send an LCP (Link Control
Protocol) echo request frame at specified intervals (in seconds). If no reply to
the request is received, the PPP connection is torn down. This functionality is
also known as 'keep-alive'.
If you do not want to send LCP echo frames, specify zero (0) in the <interval>
attribute.
17.25.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
interval
17.25.4 Example
--> pppoe set transport pppoe2 lcpechoevery 0
478
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the pppoe list
transports command.
The length of time (in seconds)
between LCP echo request frames
sent. If you do not want echo request
frames to be sent, specify '0' as the
interval.
Default value
N/A
N/A
10
2/1553-ZAT 759 94 Uen B – December 2005