Pppoe Set Transport Eth - Ericsson HM4x0 Reference Manual

17.15

pppoe set transport eth

17.15.1 Syntax
pppoe set transport {<name>|<number>} eth <port>
17.15.2 Description
This command sets the ethernet port that an existing PPPoE transport uses to
transport PPPoE data.
17.15.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
port
17.15.4 Example
--> pppoe set transport pppoe3 eth eth_lan
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the pppoe list
transports command.
The system port that is used to
transport Ethernet data. To display
Ethernet ports, use the ethernet
list ports command.
PPPoE CLI Commands
Default value
N/A
N/A
N/A
467