Pppoe Set Transport Servicename - Ericsson HM4x0 Reference Manual

Table of Contents

Advertisement

PPPoE CLI Commands
17.41

pppoe set transport servicename

17.41.1
Syntax
pppoe set transport {<name>|<number>} servicename
<servicename>
17.41.2
Description
This command specifies the service name that is acceptable to the PPPoE
client.
You can also set the access concentrator using the pppoe set transport
accessconcentrator command so that PPPoE will only accept a specific
service via a specific access concentrator.
17.41.3
Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
service
name
498
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the pppoe list
transports command.
A PPPoE tag that identifies a specific
service that is acceptable to the
PPPoE client. If set, the PPPoE
transport will connect to the first
access concentrator it finds that uses
this service. If an access concentrator
is also set, the PPPoE transport will
connect to the specified service on the
named concentrator. The service
name is determined by your ISP.
Default value
N/A
N/A
Empty string
2/1553-ZAT 759 94 Uen B – December 2005

Advertisement

Table of Contents
loading

Table of Contents