Use The Cli; Access The Cli; Login To The System - Ericsson HM4x0 Reference Manual

2

Use the CLI

This chapter provides information about how to use the HM410/HM490
Command Line Interface (CLI).
2.1

Access the CLI

To access the CLI via Ethernet local LAN, proceed as follows:
1 Connect the LAN to one of the Ethernet ports (LAN1-LAN4) on the
HM410/HM490.
2 If you use the Telnet session available under Windows for LAN and
remote access:
−
−
Note:
The Command Line is displayed.
If your Telnet application is GUI-based, you may be able to configure your
Telnet terminal preferences to allow VT-100 compatibility in order to have
scrolling and cursor arrow navigation. If your Telnet application is CLI-based,
you should have scrolling and cursor arrow navigation. Access your Telnet
application's online help (usually by typing 'help' or pressing '?'), or refer to
your Telnet client documentation for more information.
2.2

Login to the System

To login to the system for the first time, at the Login prompt, enter admin as
both user name and password:
'########:'########::'####::'######:::'######:::'######:::'#######::'##::: ##:
##.....:: ##.... ##:. ##::'##... ##:'##... ##:'##... ##:'##.... ##: ###:: ##:
##::::::: ##:::: ##:: ##:: ##:::..:: ##:::..:: ##:::..:: ##:::: ##: ####: ##:
######::: ########::: ##:: ##:::::::. ######::. ######:: ##:::: ##: ## ## ##:
##...:::: ##.. ##:::: ##:: ##::::::::..... ##::..... ##: ##:::: ##: ##. ####:
##::::::: ##::. ##::: ##:: ##::: ##:'##::: ##:'##::: ##: ##:::: ##: ##:. ###:
########: ##:::. ##:'####:. ######::. ######::. ######::. #######:: ##::. ##:
........::..:::::..::....:::......::::......::::......::::.......:::..::::..::
2/1553-ZAT 759 94 Uen B – December 2005
In the Windows start menu select Run...
In the Run dialog box enter telnet <IP address for the HM4x0>
The default IP address for the HM4x0 is 192.168.1.1 and the
connected PC must be on the same subnet, for example the IP
address set to 192.168.1.2.
Use the CLI
23