Table of Contents
Advertisement
17.17
pppoe set transport eventlevel
17.17.1
Syntax
pppoe set transport {<name>|<number>} eventlevel
<pppeventlevel>
17.17.2
Description
This command sets a debugging tracing event level for PPP. The
<pppoeventlevel> can be any value between 1 and 9. The event levels are
shown in the table below:
Level
1
2
3
4
5
6
7
8
9
17.17.3
Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
2/1553-ZAT 759 94 Uen B – December 2005
Description
Only very serious errors reported.
Definite protocol errors or very significant events reported.
Links going up/down reported.
Every packet and significant state change is reported.
Every packet sent/received is disassembled, and hex
dumped.
Levels 1-5 plus assignment of the IP addresses to the
interface and extra authentication information (CHAP/PAP)
reported.
Levels 1-6 plus tunneling reported.
Levels 1-7 plus minor phase changes reported.
Levels 1-8 plus all timer information reported.
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
PPPoE CLI Commands
Default value
N/A
469
Advertisement
Table of Contents
