Pppoa Set Transport Lcpmaxconf - Ericsson HM4x0 Reference Manual

16.24

pppoa set transport lcpmaxconf

16.24.1 Syntax
pppoa set transport {<name>|<number>} lcpmaxconf <lcp max
configure>
16.24.2 Description
This command sets the Link Control Protocol (LCP) maximum configure
number for an existing PPPoA transport.
16.24.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
lcp max
configure
16.24.4 Example
--> pppoa set transport pppoa1 lcpmaxconf 20
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
PPPoA transport. To display transport
names, use the pppoa list
transports command.
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the pppoa list
transports command.
Link Control Protocol; the maximum
number of configures that can be
transmitted without reply before
assuming that the destination address
is unable to respond. The
LCPmaxconf can be any positive
value.
PPPoA CLI Commands
Default value
N/A
N/A
10
411