Security Set Trigger Addressreplacement - Ericsson HM4x0 Reference Manual

19.21

security set trigger addressreplacement

19.21.1 Syntax
security set trigger <name> addressreplacement
{none|tcp|udp|both}
19.21.2 Description
The settings in this command are only effective if you enable address
translation using the command security set trigger
binaryaddressreplacement.
This command allows you to specify what type of address replacement is set
on an trigger. Incoming packets are searched in order to find their embedded
IP address. The address is then replaced by the correct inside host IP
address, and NAT translates the packets to the correct destination.
You can specify whether you want to carry out address replacement on TCP
packets, on UDP packets or on both TCP and UDP packets.
19.21.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
none
tcp
udp
both
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
trigger. To display trigger names, use
the security list triggers
command.
Disables address replacement.
Sets address replacement on TCP
packets for an existing trigger.
Sets address replacement on UDP
packets for an existing trigger.
Sets address replacement on TCP
and UDP packets for an existing
trigger.
Security CLI Commands
Default value
N/A
none
563