Table of Contents
Advertisement
16.9
pppoa set transport createroute
16.9.1
Syntax
pppoa set transport {<name>|<number>} createroute
{enabled|disabled}
16.9.2
Description
This command specifies whether a route is added to the system after IPCP
(Internet Protocol Control Protocol) negotiation is completed. If set to enabled,
a route will be created which directs packets to the remote end of the PPP
link.
This route can either be a default route or a specific route, depending on the
value set using the pppoa set transport specificroute command.
To display the createroute settings, use the pppoa show transport
command. The route is removed when the PPP link is disconnected.
16.9.3
Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
enabled
disabled
16.9.4
Example
--> pppoa set transport pppoa1 createroute disabled
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
PPPoA transport. To display transport
names, use the pppoa list
transports command.
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the pppoa list
transports command.
Adds a route to the system after IPCP
negotiation.
Does not add a route to the system
after IPCP negotiation.
PPPoA CLI Commands
Default value
N/A
N/A
enabled
393
Advertisement
Table of Contents
