Table of Contents
Advertisement
17.33
pppoe set transport pcr
17.33.1
Syntax
pppoe set transport {<name>|<number>} pcr <peak cell
rate>
17.33.2
Description
This command sets the peak cell rate (pcr) for an existing PPPoE transport
that performs dialout over PVC.
17.33.3
Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
peak cell
rate
17.33.4
Example
--> pppoe set transport pppoe2 pcr 50000
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the pppoe list
transports command.
Determines the maximum rate at
which ATM cells are allowed to be
sent along the PPPoE transport.
The PCR can be any value from 0 up
to the maximum PortSpeed parameter
set when the port was created (using
the port list command).
PPPoE CLI Commands
Default value
N/A
N/A
0
487
Advertisement
Table of Contents
