Ethernet Set Transport Port - Ericsson HM4x0 Reference Manual

9.7

ethernet set transport port

9.7.1 Syntax
ethernet set transport {<name>|<number>} port <port>
9.7.2 Description
This command sets the port that an existing Ethernet transport uses to
transport ethernet data.
9.7.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
port
9.7.4 Example
--> ethernet set transport LanTransport eth_lan
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
Ethernet transport. To display
transport names, use the ethernet
list transports command.
A number that identifies an existing
Ethernet transport. To display
transport numbers, use the ethernet
list transports command.
The system port that is used to
transport ethernet data. You cannot
use the same port for more than one
ethernet transport at a time.
Ethernet CLI Commands
Default value
N/A
N/A
ethernet
217