Dhcpclient Set Interfaceconfig Dhcpserverpoolsize - Ericsson HM4x0 Reference Manual

5.20

dhcpclient set interfaceconfig dhcpserverpoolsize

5.20.1 Syntax
dhcpclient set interfaceconfig {<name>|<number>}
dhcpserverpoolsize <pool size>
5.20.2 Description
This command tells DHCP client to configure a DHCP server on the LAN if the
given address pool size is set to a number greater than 0. The LAN DHCP
server is configured using parameters received by a DHCP client interface on
the WAN. Information such as DNS server addresses can then be distributed
to LAN clients. The new DHCP server gives out the default gateway address
as its LAN IP address.
5.20.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
pool size
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
DHCP client interface. To display
client interface names, use the
dhcpclient list
interfaceconfigs command.
A number that identifies an existing
DHCP client interface. To display
client interface numbers, use the
dhcpclient list
interfaceconfigs command.
The number of DHCP client
addresses in a pool. The first
address in the pool is the address
immediately after the LAN DHCP
address. For example, if the LAN
DHCP address is 192.168.102.3,
the first address in the pool will be
192.168.102.4.
DHCP Client CLI Commands
Default value
N/A
N/A
N/A
135