Pppoa Set Transport Vpi - Ericsson HM4x0 Reference Manual

16.45

pppoa set transport vpi

16.45.1 Syntax
pppoa set transport {<name>|<number>} vpi <vpi>
16.45.2 Description
This command applies to existing PVC transports – it does not apply to SVC
transports. This command sets the Virtual Path Identifier.
16.45.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
vpi
16.45.4 Example
--> pppoa set transport pppoa3 vpi 0
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
PPPoA transport. To display transport
names, use the pppoa list
transports command.
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the pppoa list
transports command.
A field in the ATM header. The VPI is
used to identify the virtual path that a
circuit belongs to. The VPI can be any
value between 0 and 4095.
PPPoA CLI Commands
Default value
N/A
N/A
N/A
439