Bridge Add Vlan - Ericsson HM4x0 Reference Manual

Bridge CLI Commands
4.18

bridge add vlan

4.18.1 Syntax
bridge add vlan <name> <vlanid> <fdb>
4.18.2 Description
This command adds a named VLAN (either the default VLAN or a user-
defined VLAN) to the bridge.
Note:
To add a VLAN, you must enter this command with the following values set:
•
•
•
By default, all of the bridge interfaces are added to the untagged port list of the
default VLAN.
4.18.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
54
The default VLAN, if needed, must explicitly be added by this
command. (The default VLAN allows forwarding of untagged frames;
by default, untagged frames are not forwarded).
<name> = DefaultVlan
<vlanid> = 1
<fdb> = DefaultFdb
Description
An arbitrary name that identifies the
VLAN. It can be made up of one or
more letters or a combination of
letters and digits, but it cannot start
with a digit.
Set to DefaultVlan to add the default
VLAN.
Default value
N/A
2/1553-ZAT 759 94 Uen B – December 2005