Ericsson HM4x0 Reference Manual page 660

System CLI Commands
For example ip rawip tracing shows that an IP packet has been
received, sent or discarded due to an error. Brief details of the packet are
displayed to identify it.
The RIP and IP modules provide separate categories which are enabled and
disabled independently. For example, if you enable ip rawip, it does not affect
ip udp, and so on.
To display a list of modules and categories and their enable/disable status,
see the system log list command.
22.18.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
enable
disable
22.18.4 Example
--> system log enable rip rx
660
Description
Enables tracing support output for a
specified specific module and module
category.
Disables tracing support output for a
specified specific module and module
category.
Default value
disable
2/1553-ZAT 759 94 Uen B – December 2005