Snmp Set Trapdestination - Ericsson HM4x0 Reference Manual

20.8

snmp set trapdestination

20.8.1 Syntax
snmp set trapdestination <name> [[community <community>]
[destination <ipaddress>] [permanently
<enabled|disabled>] [port <portNumber>] [temporarily
<enabled|disabled>] [version <v1|v2c>]]
20.8.2 Description
This command allows you to change settings to a trap destination previously
added to the system using the snmp add trapdestination command.
20.8.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
community
destination
permanently
temporarily
port
version
v1 | v2c
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing trap
destination. To display trap destination
names, use the snmp list
trapdestinations command.
The trap community name of an
existing community. To display
community names, use the snmp
list communitynames command.
The IP address of the machine that
you want traps to be send to.
The port number to which traps are
sent. A value of 0 means that traps are
sent to the SNMP agent's default trap
port number (usually 162).
The trap version to be used.
v1: trap, v2s: notification.
SNMP CLI Commands
Default value
N/A
N/A
N/A
Enabled
Enabled
0
v1
615