Dhcpclient Set Interfaceconfig Dhcpinform Enabled|Disabled - Ericsson HM4x0 Reference Manual

5.19 dhcpclient set interfaceconfig dhcpinform
enabled|disabled
5.19.1 Syntax
dhcpclient set interfaceconfig {<name>|<number>}
dhcpinform {enabled|disabled}
5.19.2 Description
This command enables/disables whether DHCP client uses the dhcpinform
message type. This DHCP message type is used whenever a client has
obtained an IP address or subnet mask (for example, the address has been
manually configured or obtained through PPP/IPCP), but wishes to obtain
extra configuration parameters (such as DNS servers or default gateway) from
a DHCP server.
5.19.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
enabled
disabled
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
DHCP client interface. To display
client interface names, use the
dhcpclient list
interfaceconfigs command.
A number that identifies an existing
DHCP client interface. To display
client interface numbers, use the
dhcpclient list
interfaceconfigs command.
Enables the dhcpinform message
type. IP address and subnet mask
will not be negotiated if this mode is
selected.
Disables the dhcpinform message
type.
DHCP Client CLI Commands
Default value
N/A
N/A
disabled
133