Pppoa Set Transport Givedns Relay Enabled|Disabled - Ericsson HM4x0 Reference Manual

PPPoA CLI Commands
16.17

pppoa set transport givedns relay enabled|disabled

16.17.1 Syntax
pppoa set transport {<name>|<number>} givedns relay
{enabled|disabled}
16.17.2 Description
This command controls whether the PPP Internet Protocol Control Protocol
(IPCP) can request the DNS server IP address for a remote PPP peer. Once
IPCP has discovered the DNS server IP address it automatically gives the
address to the local DNS relay so that a connection can be established.
16.17.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
enabled
disabled
16.17.4 Example
--> pppoa set transport pppoa1 givedns relay enabled
404
Description
A name that identifies an existing
PPPoA transport. To display transport
names, use the pppoa list
transports command.
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the pppoa list
transports command.
IPCP can request a DNS server IP
address and then give the address to
DNS relay.
IPCP cannot request a DNS server IP
address and then give the address to
DNS relay.
Default value
N/A
N/A
enabled
2/1553-ZAT 759 94 Uen B – December 2005