Table of Contents
Advertisement
16.31
pppoa set transport pcr
16.31.1
Syntax
pppoa set transport {<name>|<number>} pcr <peak cell
rate>
16.31.2
Description
This command applies to existing PVC transports – it does not apply to SVC
transports. This command sets the peak cell rate (pcr) for an existing PPPoA
transport.
16.31.3
Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
peak cell
rate
16.31.4
Example
--> pppoa set transport pppoa2 pcr 50000
2/1553-ZAT 759 94 Uen B – December 2005
Description
A name that identifies an existing
PPPoA transport. To display transport
names, use the pppoa list
transports command.
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the pppoa list
transports command.
Determines the maximum rate at
which ATM cells are allowed to be
sent along the PPPoA transport.
The PCR can be any value from 0 up
to the maximum PortSpeed parameter
set when the port was created (using
the port list command).
PPPoA CLI Commands
Default value
N/A
N/A
0
419
Advertisement
Table of Contents
