Rfc1483 Set Transport Txvpi - Ericsson HM4x0 Reference Manual

RFC1483 CLI Commands
18.18

rfc1483 set transport txvpi

18.18.1 Syntax
rfc1483 set transport {<name>|<number>} txvpi <vpi>
18.18.2 Description
This command sets the transmit Virtual Path Identifier. If you later set the VPI
using the rfc1483 set transport vpi command, the TX VPI setting will
be overridden.
The port/VCI/VPI combination must be unique for each transport.
18.18.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
txvpi
18.18.4 Example
--> rfc1483 set transport my1483 txvpi 0
534
Description
A name that identifies an existing
RFC1483 transport. To display
transport names, use the rfc1483
list transports command.
A number that identifies an existing
RFC1483 transport. To display
transport numbers, use the rfc1483
list transports command.
A field in the ATM header. The TXVPI
is used to identify the virtual path that
a circuit belongs to and transmits
information on. The TXVPI can be any
value between 0 and 4095.
Default value
N/A
N/A
VPI value set when
the transport was
created using the
rfc1483 add
transport
command.
2/1553-ZAT 759 94 Uen B – December 2005