Pppoe Set Transport Autoconnect Filter - Ericsson HM4x0 Reference Manual

PPPoE CLI Commands
17.9

pppoe set transport autoconnect filter

17.9.1 Syntax
pppoe set transport {<name>|<number>} autoconnect filter
{add|delete} {tcpport <tcpportadd>|udpport <udpportadd>}
17.9.2 Description
This command allows you to add filters to TCP/UDP ports to prevent PPP from
auto-connecting with certain IP packets.
Certain IP packet types may force an unwanted autoconnect sequence.
Setting a filter on the port used by these packets prevents them from starting
PPP autoconnect.
The delete option allows you to clear an existing autoconnect filter.
Note:
17.9.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option
name
number
add
delete
460
This command is only effective if you have already enabled PPP
autoconnection using the pppoe set transport autoconnect
command.
Description
A name that identifies an existing
PPPoE transport. To display transport
names, use the pppoe list
transports command.
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the pppoe list
transports command.
Adds an autoconnect filter to the
specified port.
Deletes an existing autoconnect filter
from the specified port.
Default value
N/A
N/A
N/A
N/A
2/1553-ZAT 759 94 Uen B – December 2005