Connection Mode; 9600 / 19200 Bps; Bits; / Multi-Link2 / Multi-Link2 (Ethernet) Rs-232C - Fuji Electric Monitouch V9 Series Connection Manual

11-2 11. MOELLER
11.1.1 PS4
Communication Setting
Editor
Communication setting
Item

Connection Mode

Signal Level
Baud Rate
Data Length
Stop Bit
Parity
PLC
PRG port
The communication parameters are fixed; baud rate: 9600 bps, signal level: RS-232C, data length: 8 bits, stop bit: 1 bit, parity:
none.
For establishing communication with the V series, register a device memory in the PLC software "S40". For more information,
refer to the PLC manual issued by the manufacturer.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
MW (Merker)
*1 The assigned device memory is expressed as shown below when editing the screen.
The addresses are expressed in "bytes". For word designation, specify an even-numbered address.
 Word device
Example: MW200
Indirect Device Memory Designation
n+0 Model
n+1
n+2 Expansion code
n+3 00
*1 Word designation
Specify an address number divided by "2".
Example: In the case of MW10, specify "5" (10 divided by 2) for the address number.
*2 Bit designation
Example: In the case of bits 0 to 7 of MW10, specify "5" for the address number and "0" to "7" for the bit designation.
Example: In the case of bits 0 to 7 of MW11, specify "5" for the address number and "8" to "15" for the bit designation.
1 : 1 / Multi-link2 / Multi-link2 (Ethernet)
Device Memory
Address number
(even number only)
Device type
*1
Address No.
*2
Bit designation
Station number
Setting
RS-232C
9600 bps

8 bits

1 bit
None
TYPE
00H *1
M as bit device
 Bit device
Example: M200 . 0
Bit number: 0 to 7
Period
Byte address number
(Underlined setting: default)
Remarks
Remarks