Fuji Electric Monitouch V9 Series Connection Manual page 369

15-8 15. Panasonic
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
Set the same PLC table number as the one set for "MEWTOCOL Station Number" ([Initial Information Setting]  [Local
Node Setting]).
PLC
Make the mode setting using the Ethernet unit "FP2-ET1".
Mode setting switch
Switch
2
Make the PLC setting using the configuration tool "Configurator ET". For more information, refer to the PLC manual issued by
the manufacturer.
Initial information setting
Local Node Setting
Connection setting
Connection
1 to 8
* Select a port to
which the V9 is
connected.
Match the number to the
MEWTOCOL station
number of the PLC.
Setting
ON Auto connection function
Item
IP Address
MEWTOCOL Station Number
Item
Communication Mode
Open Type
Usage
Local Node (PLC) Port Number
Target Node IP Address
Target Node Port Number
Target Node MEWTOCOL Station
Number
Connection Setting
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
Contents
IP address of the PLC
1 to 31
* The same number must be specified for the PLC table number of the V9.
TCP/IP
Unpassive
MEWTOCOL communication
As desired
IP address of the V9
Port number of the V9
1 to 31
* Match the number to the one set for [Local Port No.] under [Communication
Setting] on the V9.
Valid
Set the IP address, port number and
whether or not to use the KeepAlive
function of the PLC.
Remarks
Setting
Setting