Fuji Electric Monitouch V9 Series Connection Manual page 253

9-60 9. MITSUBISHI ELECTRIC
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
P (parameter)
D (parameter)
D (Parameter)
Address
D0
D1
D2
D3
D4
D5
D6
D7
D8
D9
* These memory addresses are not available for FR-S500
CAUTION
TYPE
00H
01H
Operation mode
Output frequency (Rotation)
Output current
Output voltage
Alarm contents (last / most recent)
Data Contents Data
H00 none H22
H10 OC1 H30
H11 OC2 H31
H12 OC3 H40
H20 OV1 H60
H21 OV2 H70
Alarm contents (three times before / two times before)
Alarm contents (five times before / four times before)
Alarm contents (seven times before / six times before)
Inverter status monitor
Bit 15 -
Not used
Error occurrence
Frequency detection (FU)
Changeover to second parameter
When setting device memory:
By default, only the "List" file of "FR-E500" can be browsed by pressing the [Refer] button.
If an inverter such as "A500", "F500", or "S500" is used, refer to the parameter list described in each
inverter's manual and then set the device memory.
Refer to the list file or the parameter list for the inverter.
Refer to the table below.
Name
When issuing a command, such as a run command, from the V series, select
"Communication and Run".
FR-E500 : 0002 H
FR-A500 : 0002 H
FR-F500 : 0002 H
FR-S500 : 0000 H
Contents Data Contents
OV3 H80 GF
THT H81 LF
THM H90 OHT
FIN HA0 OPT
OLT HB0 PE
BE HB1 PUE
*
*
8 7 6 5 4 3
Frequency accession (SU)
Not used
Overload (OL)
Remarks
Data Contents
HB2 RET
HC2 P24
HF3 E.3
HF6 E.6
HF7 E.7
2 1 0
Inverter running
(RUN)
Normal rotation (STF)
Reverse rotation (STR)