Fuji Electric Monitouch V9 Series Connection Manual page 5

 Do not repair, disassemble or modify the V9 series. Hakko Electronics Co., Ltd. is not responsible for any damages resulting from
repair, disassembly or modification of a unit that was performed by an unauthorized person.
 Do not use a sharp-pointed tool when pressing a touch switch. Doing so may damage the screen.
 Only experts are authorized to set up the unit, connect the cables or perform maintenance and inspection.
 Lithium batteries contain combustible material such as lithium or organic solvents. Mishandling may cause heat, explosion or
ignition resulting in fire or injury. Read related manuals carefully and handle the lithium battery correctly as instructed.
 Do not press two or more positions on the screen at the same time. If two or more positions are pressed at the same time, the
switch located between the pressed positions activates.
 Take safety precautions during operations such as changing settings during running, forced output, start, and stop. Any
misoperation may cause unexpected machine motions, resulting in machine accident or damage.
 In facilities where a failure of the V9 series could lead to accidents threatening human life or other serious damage, be sure that the
facilities are equipped with adequate safeguards.
 At the time of disposal, the V9 series must be treated as industrial waste.
 Before touching the V9 series, discharge static electricity from your body by touching grounded metal. Excessive static electricity
may cause malfunction or trouble.
 Insert an SD card into the unit in the same orientation as pictured on the unit. Failure to do so may damage the SD card or the slot
on the unit.
 The SD card access LED flashes red when the SD card is being accessed. Never remove the SD card or turn off power to the unit
while the LED is flashing. Doing so may destroy the data on the SD card. Check that the LED has turned off before removing the SD
card or turning off the power to the unit.
[General Notes]
 Never bundle control cables or input/output cables with high-voltage and large-current carrying cables such as power supply cables.
Keep these cables at least 200 mm away from the high-voltage and large-current carrying cables. Otherwise, malfunction may occur
due to noise.
 When using the V9 series in an environment where a source of high-frequency noise is present, it is recommended that the FG
shielded cable (communication cable) be grounded at each end. However, when communication is unstable, select between
grounding one or both ends, as permitted by the usage environment.
 Be sure to plug connectors or sockets of the V9 series in the correct orientation. Failure to do so may lead to damage or malfunction.
 If a LAN cable is inserted into the MJ1 or MJ2 connector on the V9 series, the counterpart device may be damaged. Check the
indication on the unit and insert a cable into the correct position.
 Do not use thinners for cleaning because they may discolor the V9 series surface. Use commercially available alcohol.
 If a data receive error occurs when the V9 series and the counterpart (PLC, temperature controller, etc.) are started at the same time,
read the manual for the counterpart unit and remove the error correctly.
 Avoid discharging static electricity on the mounting panel of the V9 series. Discharging static electricity on the mounting panel may
cause malfunction due to noise.
 Avoid prolonged display of any fixed pattern. Due to the characteristic of liquid crystal displays, an afterimage may occur. If prolonged
display of a fixed pattern is expected, use the backlight's auto OFF function.
 The V9 series is identified as a class-A product in industrial environments. In the case of use in a domestic environment, the unit is
likely to cause electromagnetic interference. Preventive measures should thereby be taken appropriately.
[Notes on the LCD]
Note that the following conditions may occur under normal circumstances.
 The response time, brightness and colors of the V9 series may be affected by the ambient temperature.
 Tiny spots (dark or luminescent) may appear on the display due to the characteristics of liquid crystal.
 There are variations in brightness and colors between units.
CAUTION