Fuji Electric Monitouch V9 Series Connection Manual page 346

13.2.14 KM100
Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Temperature Controller
Communication level
Move to the communication setting level by using the key on the operation panel and make the required settings.
When the [LEVEL] key is held down for three seconds or longer in the run level, the setting level is selected.
When the [LEVEL] key is pressed in the setting level, the communication setting level is selected.
When the [LEVEL] key is held down for one second or longer, the run level is selected again.
Communication unit No.
Baud rate
Data length
Stop bit
Parity
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
C0 Variable area (instantaneous value)
C1 Variable area (average value)
C2 Variable area (maximum value)
C000 Parameter area
Indirect Device Memory Designation
15
n + 0 Model (91 to 98)
n + 1
n + 2 Expansion code
n + 3
For bit designation, an expansion code setting is required.
00H: when designating bit 0 to 15
01H: when designating bit 16 to 31
Item
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
Item
U-no
bPS
LEn
Sbit
Prty
Device Memory
8 7
Device type
Address No.
Bit designation
00 Station number
13.2 Temperature Controller/Servo/Inverter Connection
Setting
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 / 38400 bps
7 / 8 bits
1 / 2 bits
None / Odd / Even
0 to 99
Setting
00 to 99
4800 / 9600 / 19200 / 38400
7 / 8
1 / 2
None / Even / Odd
TYPE
00H Double-word, read only
01H Double-word, read only
02H Double-word, read only
04H Double-word
0
13-59
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Remarks