Fuji Electric Monitouch V9 Series Connection Manual page 428

Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
STS (status)
OPLSC (command pulse counter)
FPLSC (feedback pulse counter)
SPD (current speed)
TLQ (current torque command)
DEVIC (current deviation counter)
INS (input signal)
OUTS (output signal)
STDC (current speed/torque/counter)
SIO (status, input signal, output signal)
FBS (feedback scale)
ABS (absolute encoder)
FSPLS (feedback scale deviation/total pulses)
IPM (parameter (individual))
CALM (current alarm data)
IALM (alarm history (individual))
AALM (alarm history (all))
IAPM (parameter/property (individual))
PAPM (parameter/property (all))
*1 Parameter values will be changed temporarily. When saving parameter changes to EEPROM, use the macro command PLC_CTL.
For more information on the command PLC_CTL, see page 15-68.
Indirect Device Memory Designation
15
n+0 Models (11 to 18)
n+1
n+2
Expansion code
n+3
* In the expansion code, set which word, higher or lower, is to be read when a double-word address is specified.
15
0
Device Memory
8 7
Device type
Address No.
*
Bit designation
00 Station number
0 0 0 0 0 0
15.2 Temperature Controller/Servo/Inverter Connection
TYPE
00H Read only
01H Double-word, read only
02H Double-word, read only
03H Read only
04H Read only
05H Double-word, read only
06H Double-word, read only
07H Double-word, read only
08H Double-word, read only
09H Double-word, read only
0AH Read only
0BH Double-word, read only
0CH Double-word, read only
0DH * 1
0EH Read only
0FH Read only
10H Read only
11H Read only
12H
Read only, except for parameter values (current values)
0
8
0: 0 to 15 bits (lower)
1: 16 to 31 bits (higher)
15-67
Remarks
*1