Fuji Electric Monitouch V9 Series Connection Manual page 437

16.1.1 CB100/CB400/CB500/CB700/CB900 (MODBUS RTU)
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Parity
Data Length
Stop Bit
Target Port No.
CB100
Communication setting mode
When the [R/S] key is pressed while the [SET] key is held down in the PV/SV display mode, the controller enters in the
"communication setting" mode.
Indication
Add Slave address
bPS Baud rate
bIT Data configuration
InT Interval time setting
Available Device Memory
The available setting range of device memory varies depending on the controller model. Be sure to set within the range
available for the controller to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
---
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
4800 / 9600 / 19200 bps
None / Odd / Even
8 bits
1 bit
1 to 31
Item Setting
1 to 31
1: 4800 bps
2: 9600 bps
3: 19200 bps
0: 8 bits / 1 bit / none
6: 8 bits / 1 bit / even
7: 8 bits / 1 bit / odd
0 to 150
TYPE
00H
16.1 Temperature Controller/Servo/Inverter Connection
Communication is not performed when "0" is set.
Interval time = set value  1.666 ms
Remarks
16-3
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks