Fuji Electric Monitouch V9 Series Connection Manual page 375

15-14 15. Panasonic
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
Set the same PLC table number as the one set for "No. 410 Unit No." ([Option]  [PLC System Register Setting]  [COM1
Port Setting]).
PLC
Make the PLC setting using the communication tool "Configurator WD" and the programming tool "FPWIN GR". For more
information, refer to the PLC manual issued by the manufacturer.
IP address setting (Configurator WD)
Basic Setting
Communication setting (Configurator WD)
Communication Mode
Action Mode
Control unit - Communication cassette Setting
Server Setting
COM1 port setting (FPWIN GP)
No. 410 Unit No.
No. 412 Communication Mode
No. 413 Communication Format
No. 415 Baud rate
Item
Unit Name Unit name of the communication cassette "AFPX-COM5"
IP Address IP address of the PLC
Subnet mask Subnet mask of the PLC
Gateway Gateway of the PLC
Item
Item
Data Length
Parity
Stop Bit
Baud rate of COM1 Port
Source Port No.
1 to 99
* The same number must be specified for the PLC table number of the V9.
Computer link
8 bits
Odd
1 bit
9600 / 115200 bps
* Match the baud rate to the one set for "Baud rate of COM1 Port" in the
[Control unit - Communication cassette Setting] of the [Communication
Setting] dialog on the communication tool "Configurator WD".
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
Set the IP address, port number and
whether or not to use the KeepAlive
function of the PLC.
Setting
Setting
Computer link
Server mode
9600 / 115200 bps
As desired
Setting