Toyopuc (Ethernet) - Fuji Electric Monitouch V9 Series Connection Manual

4.1.2

TOYOPUC (Ethernet)

Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
PLC
Hellowin
Settings can be made using the software "Hellowin" or ladder programs. For settings using ladder programs, refer to the PLC
manual issued by the manufacturer.
I/O module setting
Item
Identification Code
Module Type
Module Name
Link parameter setting
Item
Rack No.
Slot No.
Link Module Name
Ethernet setting
Item
Local Node IP Address
Connection 1 - 8 *
Initialization
* When multiple V9 units are connected, make the settings for each unit. A maximum of eight units can be connected at one time.
Other node table setting
Item
Table 1 to 16
Other Node IP Address
Other Node Port No.
B3
Special / Communication
Time chart module, computer link, Ethernet, S-NET
Select a number where the unit is mounted.
Select a number where the unit is mounted.
Ethernet
Set the IP address of the PLC.
Protocol: UDP
Local Node Port No.: Port number of the PLC
Other Node Table No.: Table number for which the V9 is registered
Initialize using the link parameter
Check each box for "Use".
Set the IP address of the V9.
Set the port number of the V9.
4.1 PLC Connection
Setting
Setting
Setting
Setting
4-5