Fuji Electric Monitouch V9 Series Connection Manual page 149

Contents
1 - 8
*5
Acquire IBFL-TC status
(PLC1 - 8)
1 - 8
Version data acquisition
(PLC1 - 8)
*1 The opening will not be changed when the iB-Flow is not connected to the takt time controller.
*2 When "9" is specified, the opening is equivalent to 0.1%.
Do not exceed "9000" with respect to the zero position when specifying the pulse count.
*3 The last operation time will be acquired.
Execute operation time acquisition when measurement start is executing.
*4 Command will not be accepted if the external input (IN) port of the IBFL-TC is Low level.
If correction status is set to "Invalid", operation time measurement stops and error output (Operation time out of range) turns OFF
(Within range).
*5 If correction status is set to "Invalid", operation time measurement stops and the forth and fifth bits (Operation time out of range)
turn OFF (Within range). To acquire operation time again, execute the "Start measurement" command.
F0
n Station number
n + 1 Command: 6
IBFL-TC status
Bit
7
n + 2
Automatic correction status
n Station number
n + 1 Command: 7
Version (16 characters)
n + 2 - n + 9
IBFL-TC Ver.x.xx
6.1 Temperature Controller / Servo / Inverter
F1 (=$u n)
6 5 4 3 2 1 0
Sensor switch A
Sensor switch B
0: OFF
1: ON
Operation 1 update flag
At update: 0  1
After executing status acquire command: 1  0
Operation 2 update flag
At update: 0  1
After executing status acquire command: 1  0
Operation 1 time out of range
0: Within range
1: Out of range
Operation 2 time out of range
0: Within range
1: Out of range
External output overcurrent
0: Normal
1: Overcurrent
0: Invalid
1: Valid
0: OFF
1: ON
6-3
F2
2
2