Xgt / Xgi Series Cnet - Fuji Electric Monitouch V9 Series Connection Manual

8.1.10 XGT / XGI Series CNET

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
PLC
Set parameters in XG-PD. For more information, refer to the PLC manual issued by the manufacturer.
Communication settings
Item
Type
Speed
Data bit
Stop Bit
Parity bit
Station Number
Calendar
This model is equipped with a calendar function; however, the calendar data cannot be written from the V series. Thus, time
correction must be performed on the PLC side.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
M (internal memory)
Q (output)
I (input)
R (internal memory)
W (internal memory)
F (system flag)
K (PID flag)
L (link flag)
N (P2P flag)
U (analog data register)
*1 The assigned device memory is expressed as shown on the
right when editing the screen.
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 / 38400 /57600 /
115200 bps
None / Odd / Even
RS-232C / RS-422
4800 / 9600 / 19200 / 38400 /57600 /
115200 bps
None / Odd / Even
Device Memory
Setting
7 / 8 bits
1 / 2 bits
0 to 31
Setting
7 / 8 bits
1 / 2 bits
0 to 31
TYPE
00H MW as word device
01H
QW as word device
02H *1
IW as word device
03H RW as word device
04H WW as word device
05H FW as word device; FW0 to FW1919: read only
06H KW as word device
07H LW as word device
08H NW as word device
09H
UW aw word device
Example: Q 0 . 0 . 0
8.1 PLC Connection
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Remarks
*1
*1
Address
Period
Slot No.
Period
Base No.
8-13