Fuji Electric Monitouch V9 Series Connection Manual page 321

13-34 13. OMRON
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
C0 (setting area 0)
C1 (setting area 0)
C3 (setting area 1)
Indirect Device Memory Designation
15
n + 0 Model (91 to 98)
n + 1
n + 2 Expansion code
n + 3
For bit designation, an expansion code setting is required.
00H: when designating bit 0 to 15
01H: when designating bit 16 to 31
PLC_CTL
Macro command "PLC_CTL F0 F1 F2"
Contents
Read controller status
Operation instructions
*1 8000 (HEX): broadcasting
Device Memory
8 7
Device type
Address No.
Bit designation
00 Station number
F0
n
n + 1
1 - 8
(PLC1 - 8)
n + 2
n
n + 1
1 - 8
(PLC1 - 8)
n + 2
TYPE
00H Double-word, read only
01H Double-word
03H Double-word
0
F1 (= $u n)
Station number
Command: 0006H
Operation status (higher byte)
00: Control in execution
(Operation in progress while the setting area is "0" with no
error occurring)
01: Control not in execution
(Other than above)
Related information (lower byte)
Bit - 7 6 5 4 3 2 1 0
Input error
Beyond the display range
*1
Station number
Command: 0030H
Communication writing
0000H: Communication writing OFF (disabled)
0001H: Communication writing ON (enabled)
Control start/stop
0100H: Channel 1 Run
0101H: Channel 1 Stop
Multi-SP
0200H: Target value 1
0201H: Target value 2
0202H: Target value 3
0203H: Target value 4
AT execution/cancel
0300H: Cancel
0301H: Execute
Write mode
0400H: Backup mode
0401H: RAM write mode
0500H: Save RAM data
0600H: Software reset
0700H: Move to set area 1
0800H: Move to protect level
Return data: Data stored from temperature controller to V series
Remarks
F2
2
Heater overcurrent (CT1)
Heater current hold (CT1)
A/D converter error
Heater overcurrent (CT2)
Heater current hold (CT2)
3