Fuji Electric Monitouch V9 Series Connection Manual page 132

5.1.3 KV10/24 CPU
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
PLC
No particular setting is necessary on the PLC.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
DM (data memory)
CH (input/output/internal auxiliary relay)
TC (timer/current value)
CC (counter/current value)
TS (timer/set value)
CS (counter/set value)
T (timer/contact)
C (counter/contact)
TM (temporary data memory)
Setting
1 : 1 / Multi-link2 / Multi-link2 (Ethernet)
RS-232C
9600 / 19200 / 38400 / 57600 bps
8 bits
1 bit
Even
0
Device Memory
5.1 PLC Connection
If a baud rate higher than 57600 bps is set,
communication is performed at 9600 bps.
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H
5-5
(Underlined setting: default)
Remarks
Remarks